Synergy 8012-13 - Jeep JK Weld-On Front Track Bar Bracket User Manual download pdf (Page 5)

4. You will be welding both sides, top and bottom of the new track bar bracket so make

sure the paint is removed from those areas.

5. The bracket should be at the same angle as the diff spreader holes. Zero against this

mounting surface and match the track bar bracket to the same angle.

6. If you are using the supplied tabs to mount a hydraulic assist steering ram, follow the

instructions below:

a) If you are using Reid Racing JK high steer knuckles, position the ram tabs as

shown below.

1 2 3 4 5 6 7 8 9 10 11

No comments

Synergy 8012-13 - Jeep JK Weld-On Front Track Bar Bracket User Manual Page 5